SCX10 2.0 BEEF TUBES - BRASS - WIDE XR MOD
SKU:
BT007BSWXR
$61.50
$61.50
These are an upgrade for the Axial SCX10 2.0 axle housing that benefit the rig in several ways. They add weight down low to help the center of gravity of your rig, enabling you to run less rotating weight in the tires. They also "Beef" up the axle housing itself to help keep from snapping the housing in half. This version is also made to match the track width of the Axial XR10 and has splined ends which will except Wraith/XR chubs and knuckles. They will work as both the front and rear axles. You will receive one new axle housing with the Beef Tubes pre-installed.. Team KNK Hardware is included! Tube weight = 2.8 o.z. per set
*Due to the machining required on the axle housing to allow the fitment of the Beef Tubes, we will only offer these pre-installed in a new axle housing.
*Wraith/XR chubs and knuckles are required.
*XR front Universal shafts required.
*Due to the machining required on the axle housing to allow the fitment of the Beef Tubes, we will only offer these pre-installed in a new axle housing.
*Wraith/XR chubs and knuckles are required.
*XR front Universal shafts required.
Only 1 left!
You may also like the following products.
XR10 UNIVERSAL SET - STOCK XR WIDTH
$38.00
Only a few left!
This is the front universal drive shaft set for the Axial XR10 Rock Crawler. Use these with our Wide XR Mod Beef Tubes.
FEATURES
Steel construction
Black in color
Fully assembled and ready for installation
INCLUDES
Two universal drive shafts
WIDE XR MOD REAR AXLE SHAFTS - D60 WIDE AXLE (XR)
$14.99
Only a few left!
Hardened heavy duty steel.
Makes the rear axle the same width as front Wide XR Mod.
Can be used with all versions of Wide XR Mod Beef Tubes.
Note:
Requires Wide XR Mod Beef Tubes.
Requires AR60 rear lockouts.
Makes the rear axle the same width as front Wide XR Mod.
Can be used with all versions of Wide XR Mod Beef Tubes.
Note:
Requires Wide XR Mod Beef Tubes.
Requires AR60 rear lockouts.
SCX10 II DIFF COVER - BRASS
$29.99
Out of stock
Our SCX10 II Differential covers are machined from solid brass. Why do you need a brass diff cover? Two reasons; 1. More added weight down low to help lower the cewnter of gravity of your rig, and 2. Better bearing clamping force that is more evenly distributed versus the stock plactic housings!
Diff covers can easily be painted or powder coated to the color of your choice.
Drilled and tapped to accept the stock hardware.
Weight = 1.1 ounces
*Each order will receive one SCX10 differential cover only. Parts in picture are for reference only.